Category Archives: Sweep

Sweep Won’t Advance

Zapper Ultra

Question:  The sweep command seems to work but gets stuck at bank 6 and won’t advance past that.  What do I do?

Answer:  This can happen if he has programmed the same number in position 6+  It gives the appearance of the frequencies not shifting.

For example:

10, 20, 30, 40, 50, 60, 60, 60, 60, 60

Will give you the impression that the zapper is stuck at position 6 at 60Khz, when it is in fact moving.

Best solution is a master reset.  See Quickstart book page 9.  Hold down <Program> and <on> when turning on machine for a master reset.

HealthProducts2

Advertisements

How To Use The Sweep and Run

Question:

As part of the Sweep description it says …run a Frequency Set at intervals of 10 min per program. Does this mean it will cycle thru a set of frequencies repeatedly for 10 min? and then wait for 10 min and so on?    Is it possible to set the time you want it to work on each frequency, say 3 sec  each or 10 sec each etc..   within the set?

Answer:

The frequencies are set to 10 minutes each.  If you wish to run shorter times then use the RUN command and do the frequency adjustments manually.
According to the manual, a requirement of 10 minutes is the minimal requirement for a comprehensive treatment at each frequency:

(From Instruction Book for Rife or Zapper)

5. Treatment Modes 5.1.
MANUAL <RUN> Mode: In RUN-mode, you are working on a single frequency and you can control the treatment time manually (e.g. RUN a single frequency for one hour, or manually run the frequency for 7 minutes on, and press RUN again to pause for a 10-minute break etc.). You do treatments with RUN-mode when you want to work specifically with only one frequency and when you know the actual frequency you want to work with. You can use a single frequency for many hours and another for five minutes

Thanks

HealthProducts2